Agilent Technologies E4400-60597 User Manual
Page 10
Agilent Technologies Firmware Upgrade Kits E4400-60230 and E4400-60597 for PSG/ESG Signal Generators
Firmware Upgrade Kits E4400-60230 and E4400-60597 for PSG/ESG Signal Generators
10
To connect the signal generator to a PC using a LAN interface card
1. Connect the signal generator to the PC as shown in the following diagram.
LAN communications require a LAN interface card installed in the PC and a LAN cable connected between the
interface card and the signal generator’s LAN connector. LAN communications require a 10Base-T LAN interface.
Contact your network administrator if problems are encountered.
2. Set LAN parameters as follows on PSG/ESG signal generators:
a. Press the following keys for the model being set:
b. Use the numeric keypad to set the desired address and press Enter.
The signal generator LAN address is not set at the factory. Contact your network administration to obtain an
appropriate IP address.
c. Set the Sockets SCPI parameters by pressing
Utility
>
GPIB/RS-232/LAN
>
LAN Services Setup
>
Sockets SCPI:
On
to use the E44x8C firmware installation tool.
Agilent E44xxB ESG Signal
Generators
Agilent E44x8C ESG Signal
Generators
Agilent E82x7C/D PSG Signal
Generators
and Agilent E824xA/5xA PSG
Signal Generators
LAN is not available on E44xxB
ESG Signal Generators.
Utility
>
GPIB/RS-232/LAN
>
LAN Setup
>
Hostname
>
(enter the instrument name) or
(IP address)
Utility
>
GPIB/RS-232/LAN
>
LAN Setup
>
Hostname
>
(enter the instrument name) or
(IP address)