Caution, Important, Do not place heavy objects on the product – Brother HL-L8350CDW User Manual
Page 4
4
DO install your product near an AC power outlet that is easily accessible. In the event of an
emergency, easy access to the plug and outlet will allow you to shut off power to the product
quickly and completely.
Plastic bags are used in the packing of your product. Plastic bags are not toys. To avoid the
danger of suffocation, keep these bags away from babies and children and dispose of them
properly.
CAUTION
The product may generate odorous gas such as ozone if used for a large volume of printing or
used in a poorly ventilated room for long hours. In addition, the product emits some chemical
substances during the printing. Ensure adequate ventilation for the product to avoid discomfort
or injury.
Avoid placing your product in a busy area. If you must place it in a busy area, ensure that the
product is in a safe location where it cannot be accidentally knocked over, which could cause
injury to you or others and serious damage to the product. Also ensure that cords are secured
so as not to pose a tripping hazard.
DO NOT eat the silica gel pack, please throw it away. If ingested seek medical attention
immediately.
DO NOT place heavy objects on the product.
DO NOT place this product on an unstable cart, stand, or table, particularly if children are
expected to be near the product. The product is heavy and may fall, causing injury to you or
others and serious damage to the product. For MFC and DCP products, there is an added risk
of injury if the scanner glass should break.
IMPORTANT
• DO NOT put objects on top of the product. Doing so could increase the risk of overheating
should the product malfunction.
• DO NOT place your product next to devices that contain magnets or generate magnetic fields.
Doing so may interfere with the operation of the product, causing print quality problems.
• DO NOT place your product next to sources of interference, such as speakers or the base units
of non-Brother cordless telephones. Doing so may interfere with the operation of the product's
electronic components.