Brother MFC-J4410DW - Manual (Page 41)

Dialing and storing numbers
35
5
NOTE
• (USA only) If you redial from the Caller ID
history outside your area code, you must
set up your AREA CODE in advance.
(See Setting up your area code (USA
only) on page 32.)
• You can print the Caller ID history List.
(See How to print a report on page 41.)
Dialing access codes and
credit card numbers
5
Sometimes, you may want to choose from
several long-distance carriers when you send
a fax. Rates may vary depending on the time
of day you’re sending the fax and the
destination to which you're sending it. To take
advantage of low rates, you can store the
access codes of long-distance carriers and
credit card numbers as Speed Dial numbers.
You can store these long dialing sequences
by dividing them and setting them up as
separate Speed Dial numbers in any
combination. You can even include manual
dialing using the dial pad. (See Basic User’s
Guide: Storing Speed Dial numbers.)
For example, you might have stored ‘555’ on
Address Book: 03 and ‘7000’ on Address
Book: 02. You can use them both to dial
‘555-7000’ if you press the following buttons
on the Touchscreen:
a
Press (Fax).
b
Press (Address).
c
Press Numerical.
d
Press s or t on the Touchpanel to
display #03.
e
Press #03.
f
Press Send a fax.
g
Press Options.
h
Press s or t to display
Address Book.
i
Press Address Book.
j
Press Numerical.
k
Press s or t to display #02.
l
Press #02.
m
Press Send a fax.
n
Press Fax Start.
You will dial ‘555-7000’.
To temporarily change a number, you can
substitute part of the number with manual
dialing using the dial pad. For example, to
change the number to 555-7001 you could
press (Address), press 03, press
Send a fax and then press 7001 using the
dial pad.
NOTE
If you must wait for another dial tone or
signal at any point in the dialing sequence,
create a pause in the number by pressing
Pause. Each key press adds a
3.5-second delay. You can press Pause
as many times as needed to increase the
length of the pause.