How to set a new default for scan to ftp, Setting the new default, 4how to set a new default for scan to ftp – Brother DCP-385C User Manual
Page 125
Network Scanning (For models with built-in network support)
117
4
How to set a new default for Scan to FTP
4
You can set your own default settings for Quality, File Type, Glass ScanSize and File Name.
Setting the new default
4
a
Press the
(Scan) key.
b
Press a or b to choose Scan to FTP.
Press OK.
c
Press a or b to choose <Manual>.
Press OK.
Note
If there is no FTP Profile configured, skip c and go to d.
d
Enter the FTP host address (for example ftp.example.com up to 60 characters) or the IP address (for
example 192.23.56.189).
Press OK.
e
Enter the destination folder (for example /brother/abc/, up to 60 characters).
Press OK.
f
Enter the username. Press OK.
g
Enter the password. Press OK.
h
Press and choose your new setting. Repeat this step for each setting you want to change.
i
After changing the last setting, press a or b to choose Set New Default.
Press OK.
j
Press 1 to choose Yes.
k
Press Stop/Exit.