Brother MFC-490CW - Manual (Page 18)

18
Macintosh
® USB
For USB Interface Users (For Mac OS
®
X 10.2.4 or greater)
15
Before you install
a
Make sure your machine is connected to the
power and your Macintosh
®
is ON. You must
be logged on with Administrator rights.
16
Connect the USB cable
a
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
b
Connect the USB cable to the USB socket
marked with a
symbol. You will find the
USB socket inside the machine on the right as
shown below.
c
Carefully route the USB cable through the
trench and out the back of the machine as
shown below and connect the cable to your
Macintosh
®
.
d
Lift the scanner cover to release the lock a .
Gently push the scanner cover support
down
b and close the scanner cover c .
Important
• For Mac OS ® X 10.2.0 to 10.2.3 users,
upgrade to Mac OS
®
X 10.2.4 or greater. (For
the latest information for Mac OS ® X, visit
http://solutions.brother.com/)
• Make sure there are no memory cards or a
USB Flash memory drive inserted.
Important
• DO NOT connect the machine to a USB port
on a keyboard or a non-powered USB hub.
• Connect the machine directly to your
Macintosh
®
.
Important
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
LAN USB
1
3 2