Brother MFC-665CW - Manual (Page 152)

136
Error messages
B
As with any sophisticated office product, errors may occur. If this happens, your machine identifies
the error and shows an error message. The most common error messages are shown below.
You can correct most errors by yourself. If you need more help, the Brother Solutions Center offers
the latest FAQs and troubleshooting tips.
Visit us at http://solutions.brother.com.
Error Message Cause Action
Comm.Error
Poor phone line quality caused a
communication error. Send the fax again or connect the machine
to another telephone line. If the problem
continues, call the telephone company and
ask them to check your phone line.
Connection Fail
You tried to poll a fax machine
that is not in Polled Waiting mode.
Check the other fax machine's polling
setup.
Cover is Open
The scanner cover is not closed
completely.
Lift the scanner cover and then close it
again.
The ink cartridge cover is not
completely closed. Firmly close the ink cartridge cover until it
clicks.
Data Remaining
Print data is left in the machine's
memory. Re-start printing from your computer.
Print data is left in the machine's
memory. The USB cable was
unplugged while the computer
was sending the data to the
machine.
Press Stop/Exit. The machine will cancel
the job and clear it from the memory. Try to
print again.
Disconnected
The other person or other
person's fax machine stopped the
call. Try to send or receive again.
Document Jam
The document was not inserted or
fed properly, or the document
scanned from the ADF was too
long.
See Using the ADF on page 11.
See Document jam on page 140.
DR Mode in Use
The machine is set to Distinctive
Ring mode. You cannot change
the Receive Mode from Manual to
another mode.
Set Distinctive Ring to off. (See Turning off
Distinctive Ring on page 55.)
High Temperature
The print head is too warm. Allow the machine to cool down.
Ink Empty
One or more of the ink cartridges
is empty. The machine will stop all
print operations. While memory is
available, black and white faxes
will be stored in the memory. If a
sending machine has a color fax,
the machine's
‘ handshake ’ will
ask that the fax be sent as black
and white. If the sending machine
has the ability to convert it, the
color fax will be stored in the
memory as a black and white fax.
Replace the ink cartridges. (See Replacing
the ink cartridges on page 143.)