Brother FAX-1820C - Manual (Page 31)

INTRODUCTION 1 - 11
When the TAD is in use, the LCD shows Telephone .
Connections
The external TAD must be plugged into the back of the machine, into
the jack labeled EXT. Your machine cannot work properly if you plug
the TAD into a wall jack (unless you are using Distinctive Ring).
1
Plug the telephone line cord from the telephone wall jack into the
back of the machine, in the jack labeled LINE.
2
Plug the telephone line cord from your external TAD into the
back of the machine, in the jack labeled EXT. (Make sure this
cord is connected to the TAD at the TAD’s telephone line jack,
and not its telephone jack.)
3
Set your external TAD to four rings or less. (The machine’s Ring
Delay setting does not apply.)
4
Record the outgoing message on your external TAD.
5
Set the TAD to answer calls.
6
Set the Receive Mode to External TAD .
(See Choosing the Receive Mode on page 5-1.)
Unless you are using Distinctive Ring, do not connect a
TAD elsewhere on the same phone line.
TAD
TAD
(MFC-3220C)