Antec P183 User Manual
Page 8
7
2.7
E
XTERNAL
3.5”
D
EVICE
I
NSTALLATION
There is one external 3.5” drive bay.
1. Carefully remove the plastic drive bay cover and metal plate covering the drive bay.
2. Find a pair of 3.5”drive rails in the included hardware kit box.
3. Mount the drive rails onto the sides of the 3.5” device. Make sure the metal portion is angled on
the outside and facing forward.
4. Slide the device into the drive bay until it clicks into place.
5. Connect a small 4-pin connector from the power supply to the 4-pin connector on the floppy drive.
2.8
E
XTERNAL
5.25”
D
EVICE
I
NSTALLATION
There are four 5.25” drive bays that need a total of eight drive
rails.
1. Carefully remove the drive bay cover/filter assembly by
pressing the two tabs inward, then remove the metal plate
covering the drive bay.
2.
Mount the drive rails onto the sides of the 5.25” device.
Make sure the metal tab is angled away from the drive.
3. Slide the device into the drive bay until it clicks into place.
4. Mount the other devices accordingly.
5. Connect the appropriate Molex or SATA connector from the
PSU to the power connector on each of the devices.