Brother MFC-5895CW - Manual (Page 36)

36
Windows
® Wireless Network
j
The installation of the Brother drivers will
automatically start. The installation screens
appear one after another.
k
When the On-Line Registration screen is
displayed, make your selection and follow the
on-screen instructions. Once you have
completed the registration process, close your
web browser to return to this window.
Then click Next.
Note
• If there is more than one machine connected to
the network, choose your machine from the list,
and then click Next.
This window will not appear if there is only one
machine connected on the network, it will be
chosen automatically.
• If your wireless settings fail, an error message
will appear during the installation of MFL-Pro
Suite and the installation will be terminated.
Confirm your settings by following the on-
screen instructions. If you encounter this
failure, go to step
17-a on page 29 and setup
the wireless connection again.
• If you are using WEP and the LCD displayed
Connected but your machine is not found,
make sure you entered the WEP key correctly.
The WEP key is case sensitive.
• If the IP address of the machine is not yet
configured for use on your network, the
following screen appears.
Click OK and then click
Configure IP Address. Enter an IP address
for your machine that is suitable for your
network by following the on-screen
instructions.
IMPORTANT
DO NOT cancel any of the screens during the
installation. It may take a few seconds for all
screens to appear.
Note
For Windows Vista
®
and Windows
®
7, when the
Windows Security screen appears, click the
check box and click Install to complete the
installation correctly.