Alvin XV-3-XB - Manual

Fold-A-Matic Spacesaver
Tools Required: Phillips screwdriver, drill with 1 /
8
" bit.
Assembly Instructions
Figure 1
For models XV-3-XB,
XV-4-XB, XX-3-XB, XX-4-XB
Parts Included:
(Parts A, C, D, E, F come pre-assembled)
A
1pc Leg Frame
Unpack all parts and inspect to confirm that all are present.
Place tabletop (B) with preferred side facing down on carpeted
or protected floor. For 24" x 36" top, measure 5" from base edge
of board and place frame on board. For 31" x 42" top, measure 7"
from base edge of board and place frame on board.
Left and right edges of frame (A) should be an equal distance
from each side of the tabletop as shown in Figure 1.
With the frame now centered on the tabletop, using a 1 /
8
" drill bit,
gently drill ¼" deep holes through the holes in the two mounting
brackets (A).
Wrap masking tape ¼" from drill bit end to determine drilling
depth. Take care to drill only ¼" deep to avoid drilling through and
damaging tabletop surface.
Using the Phillips screwdriver, securely screw the mounting
brackets to the tabletop using the supplied screws as shown in
Figure 1. Carefully return the table assembly to the upright position.
Adjust tabletop as desired using the angle adjustment knobs (E).
Level the legs with the adjustable height glides (F).
You’re finished and your table is ready to use as shown in Figure 2.
1
2
3
4
5
TIP
B 1pc Tabletop
C 2pcs Board
Mounting Brackets
D
2pcs Angle Adjustment Brackets
E
4pcs Angle
Adjustment Knobs
F
2pcs Adjustable
Height Glides
G
8pcs 1 /
2
" Wood
Screws
Figure 2
Model Base Top
XV-3-XB Black 24" x 36"
XV-4-XB White 24" x 36"
XX-3-XB Black 31" x 42"
XX-4-XB White 31" x 42"
Fold-A-Matic
Spacesaver Models
©2008 ALVIN & COMPANY, INC. • P.O. Box 188, Windsor, CT 06095-0722
Phone: 860-243-8991 • Toll-Free: 800-444-2584 • Fax: 860-242-8037 • Toll-Free Fax: 800-777-2896
www.alvinco.com
LIT-A8059 4/08
½"
Screws
To Assemble:
(Shipped in separate box)