Brother MFC-J6920DW - Manual (Page 34)

34
For Wireless Network Users
20 Manual setup from the
control panel using the
Setup Wizard
(Windows
®
,
Macintosh and mobile devices)
a
Press .
Press Setup Wizard.
When Switch Network interface to
wireless? is displayed, press Yes to accept.
This will start the wireless setup wizard.
To cancel, press No.
b
The machine will search for available SSIDs. It
will take several seconds to display a list of
available SSIDs.
If a list of SSIDs is displayed, swipe up or down,
or press a or b to choose the SSID you wrote
down in step
19-b on page 32.
Press OK.
If the wireless access point/router of the
selected SSID supports WPS and the machine
asks to use WPS, go to
c.
If the machine asks you to enter a Network
Key, go to
d.
Otherwise, go to e.
c
Press Yes to connect your machine using
WPS. (If you choose No (Manual) to
continue manual configuration, go to
d to enter
a Network Key.)
When the Touchscreen instructs you to start
WPS, press the WPS button on your wireless
access point/router, and then press Next to
proceed.
Go to
e.
d
Enter the Network Key you wrote down in
step
19-b on page 32 using the Touchscreen.
Press OK when you have entered all the
characters, then press Yes to apply your
settings.
e
Your machine will now try to connect to your
wireless network. It may take a few minutes.
Press OK.
Wireless setup is now complete.
The Wi-Fi LED on the control panel
lights up, indicating that the machine’s
Network I/F is set to WLAN.
For mobile device users:
• Connect your mobile device to a wireless access
point/router using a Wi-Fi connection.
• Download and install Brother iPrint&Scan
(Android™/iOS/Windows
®
Phone) from your
mobile device’s application download site. You can
also use AirPrint (iOS) with this machine.
• To download the User’s Guide for the application
you are using (Brother iPrint&Scan/AirPrint), visit
the Brother Solutions Center and click Manuals on
your model’s page.
Now go to
http://solutions.brother.com/
To install MFL-Pro Suite, continue to
step 21.
For Windows
®
users:
Now go to
Page 38
For Macintosh users:
Now go to
Page 41
You must have the wireless settings you
wrote down for your network in step
19-b on
page 32 before you proceed.
NOTE
• If the list is blank, check that the wireless
access point/router has power and is
broadcasting the SSID. Move your machine
closer to the wireless access point/router and
try starting from
a again.
• If your access point is set to not broadcast the
SSID, you will have to manually add the SSID
name. For more information, see Configure
Your Wireless Network When the SSID Is Not
Broadcast in the Software and Network User’s
Guide.
NOTE
Press to cycle between lower case and
upper case. Press to cycle between
letters, numbers and special characters. (The
characters available may differ depending on
your country.) To move the cursor to the left or
right, press d or c.
(For more information, see Entering Text
on page 44.)
NOTE
If the connection failed, check the error code on
the printed report and refer to Troubleshooting
on page 36.