AGFA Printer - Manual (Page 15)

: ANAPURNA L/XL OPERATOR MANUAL
A B]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]
15
] 8/09/2006 ]
5.6. Ink Refill System – what can go wrong…
- Wrong ink in Main ink tank:
-
Observed during ink-fill:
- Press emergency stop.
- Drain main tank, taps are situated behind a plate, under the Ink Tank Indicator.
- Rinse the main tank with cleaning solution, by using a squeeze bottle.
- Fill the ink tank again, and bleed the ink-filter
- The Ink filters are situated behind the Refill System panel
Loosen top cap (2) of filter
Push “Manual feeding” button
till ink drips out of top cap
Close top cap, tighten by hand
-
Observed during printing:
- The customer needs to call the Service Engineer
- “Empty” and “Feeding” led stay lighted ON:
-
Operator:
- Check the ink level in the tank visually
- Push the Manual Feed button
If the problem persists….
- Push emergency stop and restart the system
If the problem persists….
- Call the Service Engineer
5.7. Waste Tank
- When the waste tank is full, the blue lamp
will flash on the Signal tower, together with
a beep-alarm.
- The waste tank is located under the conveyor belt,
on the Purge-side of the engine.
Open the tap underneath to empty the tank.
- Make sure the UV-ink is kept separately from
solvent ink, do not mix them in a waste container.