American Dynamics SpeedDome Ultra Outdoor Housing ADSDUHOVRS - Manual (Page 3)

SPEEDDOME ULTRA OUTDOOR HOUSING 8200-0492-02, REV. C
INSTALLATION GUIDE - CONTINUATION 3 of 12
SpeedDome ® Ultra
Outdoor Housing
Installation Guide–Continuation
ADSDUHOC
ADSDUHOS
ADSDUHOVRC
ADSDUHOVRS
Contents:
To the Installer....................................................... 3
About the Product.................................................. 3
Parts Supplied ....................................................... 3
Tools Required ...................................................... 3
Warnings and Cautions......................................... 4
Preventing Condensation...................................... 5
Parts List for Authorized Users ............................. 5
Connector Pin Assignments.................................. 6
Cable Requirements.............................................. 6
Housing Termination and Video Configuration ..... 7
Troubleshooting..................................................... 9
Specifications ...................................................... 11
Declarations ........................................................ 12
© 2008 Sensormatic Electronics Corp.
To the Installer
This guide assumes that the outdoor mounting
structure to which the housing is attached is in
place and that data and power cables have been
pulled to the installation site. To install the outdoor
mounting structure, see documents shipped with
the structure.
About the Product
The outdoor housing has a sunshield cover and
bubble that protect the SpeedDome Ultra dome
camera. Tamperproof screws affix the bubble to
the housing.
The housing is temperature controlled and
weatherproof. A built-in thermostat and heater
prevent ice from forming on the outside of the
bubble.
The non-vandal resistant version has four alarm
inputs and one SPDT relay. Surge protection is
provided on all external lines, including video.
Parts Supplied
• Housing assembly 0101-0115-03
• Housing assembly, vandal-resistant
0101-0116-03
• Bubble assembly 0404-1402-01 (Clear) /
-02 (Smoked)
• Tamperproof drive 1400-0149-01
• Install kit 0352-0248-03
Purchase or Supply Separately
Male BNC connector
Tools Required
• 6.6mm (1/4in) fixed-handle nut driver for
Torx bit
• Wire cutters and strippers
• 2.5mm (0.1in) slotted screwdriver