AVerMedia Technologies AVERDIGI EB1304 - Manual (Page 24)

18
OSD MENU Description
010 SEC
010 SEC
NOT INSTALLED
NOT INSTALLED
NOT INSTALLED
NOT INSTALLED
SENSOR SETUP
SENSOR REC TIME
ALARM OUT TIME
CHANNEL - 1
CHANNEL - 2
CHANNEL - 3
CHANNEL - 4
SENSOR REC TIME :
Set the amount of time (in second) to start record when
the sensor has triggered
ALARM OUT TIME :
Set the amount of time (in second) to continue sending
the alarm once triggered
CHANNEL 1~4 :
Customize the initial state of the attached sensor. Refer
to the table below to customize the sensor state
Condition Description
NOT INSTALLED Indicates that there is no sensor connected
NORMAL OPEN Indicates that the initial state of the sensor is
normal open. Video recording initiates when
there is a changes in the sensor state
NORMAL CLOSE Indicates that the initial state of the sensor is
normal close. Video recording initiates when
there is a changes in the sensor state
1 2 3 4
L
010 SEC
MOTION SETUP
MOTION CAMERA
SENSITIVITIY
MOTION RECORD TIME
MOTION CAMERA :
Enable/disable the channel number to detect motion.
SENSITIVITY :
Set the sensitivity level. The sensitivity is from H (High),
9~ 2 and L (Low).
MOTION RECORD TIME :
Set the amount of time (in second) to record when
motion is detected.
1 2 3 4
5001
5005
NETWORK SETUP
IP MODE
NW ENABLE
VIDEO PORT
UPGARDE PORT
STATIC
NETWORK SETUP:
Setup the network parameters for the internet or
intranet remote monitor or playback.
IP MODE:
The system provides 3 types of IP setup mode – Static,
DHCP, and PPPOE.
Use ▲ and
▼
buttons to go up and down and
select IP MODE, and then press . Use ▲ and
▼
buttons to change the selections and press
or
▼
to make a selection.
„ STATIC: Assigns a constant IP address for the
DVR system. Use ▲ and
▼
buttons to go
up and down and select items, and then press
or
▼
to make selection. Use
▼
and
▼
to move left and right to select or enter the
configuration value.
-
IP ADDRESS: Assign a constant IP address
which a real IP addresses give from ISP to DVR
system.
- SUBNET: It is a bitmask used to identify the sub
network and how many bits provide room for