Aiwa CDC-Z107 - Manual (Page 31)

1-1 How to Activate CD Test Mode
1) Connect 62 pin (test) of IC701 (LC72358N-9910) on
MAIN C.B to the 31 pin (VDD) by cable.
2) Connect wire of ACC (red) and BACKUP (yellow) of power supply/speaker connector to DC+12V,
then connect Ground (black) to -.
When CD test mode is started, all displays will be lighted as shown in the following figure.
1-2 How to cancel CD Test Mode
1) Disconnect the cable of 62 pin (test) and 31 pin (VDD) of the MAIN C.B
IC701 (LC72358N-9910) and switch on the power.
1-3 CD Test Mode Functions
• Do not insert a Disc when confirming Search Mode
• Press PWR button when cancelling Search Mode. Test Mode will be restored when PWR button is
pressed once again.
• Insert the “Test Disc” when operating all modes except search mode.
* NOTE 1
: There are CD operations are disable owing to the protection circuit being operated when heat builds up in the driver IC
if the focus search is operated continually for more than 10 minutes. In cases, the power supply should be switched off
for 10 minutes until heat has been reduced and then re-started.
MODE Keys to operate Display Operations Contents
Start Mode All lightented • Start TEST MODE
Search Mode RANDOM TOC • Continual Focus Search • Confirm APC circuit
READING (The pickup lens respeats the • Laser current measurement
full-swing up-down motion) • Confirm focus error waveform
* NOTE 1
Play Mode REP 1 TRACK No. • Normal Play Back • Focus servo
Playing Time Indica- • Focus search is contiuned if • Traking servo
tion Revel/Ing TOC cannot be read • CLV servo
Indication • Sled servo
Traverse INT Track no. & Playing • Pause Status • Traking servo OFF
Mode Time Indication
Thread Mode All lightened • Pick up Move to outer most track • Thread servo
• Pick up Move to inner most track • Confirm mechanism operation
Gain Switch 1 All lightened • Step 1 : For CD/CD-R • Step 1 to 3 are cyclic
(Preset Button) • Step 2 : For CD-R RF Gain is up • “Error 03” is indicated if the Disc
against Step 1 does not Step 1 match.
• Step 3 : For CD-R Laser Power Up
against Step 2
Caution when servicing
(1)
How to use extension jig.
Correct between MAIN C.B. and CD mechanisms by extension jigs when checking CD mechanism
(TN-CCD1001-113J) operation.
(Refer to the following figure.)
Parts Description AKC-JIG Parts Number SV-J00-075-010
- 31 -
CD TEST MODE