Anycom PM-400 - Manual (Page 14)

INSTALLATION
14
Important: Please DO NOT plug the adapter into the operating printer.
Make sure the printer is OFF.
1. Switch the printer off. Remove a possible printer cable from USB or parallel printer interface.
2. Connect the printer adapter with the USB interface of your printer or plug the printer adapter to the parallel
port of your printer.
3. Switch the printer on.
4. Connect the power supply to the adapter. Please proceed as follows: firstly put the cable into the adapter,
secondly put the power supply’s plug into the power socket. The green power LED is on (it means power
is on) and the blue Bluetooth LED is
flashing once a second. With the printer turned on the yellow printer
LED is ON , too.
5. Now you have to initiate a new Bluetooth connection on your PC or PDA. Please proceed as follows: Open
the Bluetooth software on your device. Start searching with your software for new Bluetooth devices in the
environment [e.g. Widcomm-Stack signals: Entire Bluetooth Neighborhood]
Note: Please see your PC’s or PDA’s manual for detailed procedure. For some standard packages you can find
detailed instructions on the Utility CD or online at www.anycom.com.
English