Programming instructions – Allstar Products Group 104078 User Manual

Page 3

Advertising

Write the settings of your transmitter DIP switches into the Transmitter Code table:

PROGRAMMING INSTRUCTIONS

Factory Default

Your Transmitter Code

STEP 3:

Now program your keypad:

1. Press the ON/Reset button.

2. Enter the Factory Default PIN, 1, 2, 3, 4

3. Press key #

4. Press key #

5. Press key 1

6. Enter the Transmitter Code you filled in above

7. Press key #

The Transmitter Code is now programmed into your Keypad.

Dual or Triple Button Transmitter

If your gate or door operator has a two or three button transmitter:

STEP 1:

Locate your transmitter and open the coding hatch. You will

see a coding switch block with numbers from 1 to 8 The possible setting
for each switch is either “+”, “0” or “-”. Translate these settings into a
numeric code:

+ = 1

0 = 2

- = 3

STEP 2:

Copy the transmitter code as it is currently set into the table

below.

For example, Figure 4 shows DIP switch settings of:

+, 0, +, -, +, 0, +, -

The numeric equivalent is:

1, 2, 1, 3, 1, 2, 1, 3

Example Table:

1 2

3 4

# #

1 1

2 1

3 1

2 1

Primary PIN

DIP Switch Settings from

Transmitter

Transmitter
Button Code

+
0

1 2 3 4 5 6 7 8

Figure 4

Write the settings of your transmitter DIP switches into the Transmitter Code table:

Note the “Transmitter Button Code” box in the table below. You must also program the code for the specific transmitter button that you will use to
open the gate or door. On a two button transmitter, the left button code is 1, and right button code is 2. On a three button transmitter the left button
code is 1, the middle button code is 2, and the right button code is 3. If you are programming the keypad so that the left transmitter button opens the
gate or door, you will enter a 1 in the “Transmitter Button Code” box below.

Factory Default

Your Transmitter Code

Transmitter Button

Code