Compliance, Caution in using the projector via networks, Caution in using network function – Canon LV-7392A User Manual

Page 2: Federal communications commission notice, Canadian radio interference regulations

Advertising
background image

2

Compliance

CAUTION IN USING THE PROJECTOR VIA NETWORKS

When you find a problem with the projector, remove the power cable immediately and

inspect the unit. Using the projector with failure may cause fire or other accidents.

If you remotely use the projector via networks, carry out a safety check regularly and

take particular care to its environment. Incorrect installation may cause fire or other

accidents.

CAUTION IN USING NETWORK FUNCTION

We assume no responsibility for the loss or damage of data, or damage of the computer

caused by using this projector. Making back-up copies of valuable data in your

computer is recommended.

Federal Communications Commission Notice

Model: LV-7292A, LV-7297A, LV-7392A, LV-8227A

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equip-

ment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.

Use of shielded cable is required to comply with class B limits in Subpart B of Part of FCC

Rules.

Do not make any changes or modifications to the equipment unless otherwise specified in

the instructions. If such changes or modifications should be made, you could be required to

stop operation of the equipment.

Canon U.S.A., Inc.

One Canon Plaza, Lake Success, NY 11042-1198, U.S.A.

Tel No. (516)328-5600

Canadian Radio Interference Regulations

This class B digital apparatus complies with Canadian ICES-003.

Advertising
This manual is related to the following products: