Appendix, Confirming ip address settings, Confirming ipv4 address settings – Canon i-SENSYS MF5980dw User Manual
Page 34
33
Appendix
Confirming IP Address Settings
•
If the machine is not connected to the network properly
The IP address will not be displayed.
•
When the startup time setting is specified
The IP address, subnet mask, and gateway address will be displayed when the specified time has elapsed.
e-Manual -> "Specifying a Delay Before Establishing the Network Connection"
•
When the machine is connected to a switching hub
The machine may not be able to connect to a network even though your network settings are appropriate. In
this case, the startup time of the machine needs to be set to a waiting state.
e-Manual -> "Specifying a Delay Before Establishing the Network Connection"
Confirming IPv4 address settings
1
Press [
] (Status Monitor/Cancel) .
2
Press [
] or [
] to select <Network Information>, and then press [OK] .
Status Monitor/Cancel
TX Job
RX Job
Fax Forwarding Erro
...
Network Information
3
Press [
] or [
] to select <IPv4>, and then press [OK] .
Network Information
IPv4
IPv6
Wireless LAN Informa
...
IEEE802.1X Error Inf
...