Canon imageCLASS D1350 - Manual (Page 88)

6-2
U
sing
the
Fax
Func
tions
Basic Procedures for Sending Faxes
This section describes the basic procedure for sending faxes.
1
Place your document.
“Placing Documents” ( →P. 2-4)
“Supported Document Types” ( →P. 2-2)
2
Press [ ].
4
Specify the destination.
These are the following methods to specify a destination.
(For details, see P.6-4 to 6-5.)
Entering the fax number
One-touch keys
Coded dial codes Group dialing
Address book
- Sequential broadcast
( →P.6-10)
5
Press [ ] (Start).
When your document is placed in the feeder
The scan starts. Your document is sent to the destination when the
scan is complete.
When your document is placed on the platen glass
Perform the following procedure.
(1) Select the size of the original document using [
] or [ ] and
press [OK].
Scan Size
LTR
LGL
STMT
(2) Place the next page on the platen glass and press [ ] (Start).
Press [ ] (Start) for each page.
(3) When all documents are scanned completely, select <Start
Sending> using [ ] or [ ] and press [OK].
Your document is sent to your fax destination.
3
Specify the scanning settings as needed.
There are the three items you can specify.
(For details, see P.6-3.)
Resolution
Density
2-Sided Original
Sharpness
The settings specified here are effective only for the
current sending operation. To make the settings
effective for all the fax operations, see “Changing the
Default Fax Settings” ( →P. 6-21).