Canon imagePROGRAF iPF765 - Manual (Page 106)

Other problems Other problems
The printer does not go on ......................................................................................................................... 106
The printer takes time to start up ................................................................................................................ 106
If the Printer Makes a Strange Sound ......................................................................................................... 106
Messages advising to check the maintenance cartridge are not cleared ................................................. 107
The printer consumes a lot of ink ................................................................................................................ 107
Ink Level Detection ..................................................................................................................................... 107
The printer does not go on The printer does not go on
Cause Corrective Action
The printer is unplugged. Plug the power cord into the outlet, and then turn on the printer.
The specified voltage is not supplied. Check the voltage of the outlet and breaker.
(See "Specifications.")
→User's Guide
The printer takes time to start up The printer takes time to start up
Cause Corrective Action
The printer may have shut down incorrectly last time. This may happen
after power outages or if the printer is unplugged before it is turned off.
In this case, the next time power is restored, the printer's hard disk is
checked, and startup may take some time. Please wait a while, because it may take several minutes to
finish checking the hard disk.
If an error message is displayed after the hard disk check, fol-
low the instructions indicated to resolve the problem.
If the Printer Makes a Strange Sound If the Printer Makes a Strange Sound
Cause Corrective Action
The printer
makes a sound
during opera-
tion. The following sounds do not indicate a problem with the printer.
•
There is a sound of suction from the Platen
To prevent paper from rising, paper is held against the Platen by suction from Vacuum holes under it.
•
There is a sound when a different size of paper is used and when the Carriage goes from side to side
When paper of a different size is used, a valve is automatically activated to switch the area for paper suction, which
may make a sound. This mechanism prevents suction from Vacuum holes where there is no paper.
In addition, ink is ejected in sync with the movement of the Carriage back and forth to ensure optimal ink flow. At this
time, the valve automatically switches the area for paper suction, which may make a sound.
• Roll paper makes a fluttering sound during printing
There may be a fluttering sound when large paper is advanced.
• If you suddenly hear the tone for cleaning operations
At regular intervals, for printer maintenance, cleaning operations will begin automatically, even if the printer is in
Sleep mode.
• If you suddenly hear the tone for ink agitation
At regular intervals, to ensure optimal printing quality, the ink is agitated automatically, even if the printer is in Sleep
mode. Ink agitation takes about 30 seconds.
The ink is also agitated automatically under the following conditions. Note that other operations are not possible
while "Agitating" is displayed on the control panel.
•
After the printer is turned on. (The time for agitation varies depending on how long the printer was off—between
about 30 seconds and two minutes.)
•
After data transmission. (After about a minute and a half, printing operations begin. However, printing may start
later after data reception, depending on the size of print data.)
•
After ink tank replacement. (Ink agitation takes about three and a half minutes.)
In other cases, contact your Canon dealer.
The printer does not go on iPF765
Basic Guide
Troubleshooting
Other problems
106