Canon LV-8320 - Manual (Page 47)

47
Setting
Setting
 Note:
• During Auto input is in progress, If the MENU
button or the POWER button is pressed, Auto
input will stop. If the COMPUTER 1/2 or VIDEO
or COMPONENT or S-VIDEO or HDMI button is
pressed, Auto input will stop and go back to the
button's input signal.
• Auto input, Auto PC and Auto keystone can not
be set Off at the same time.
• Auto keystone corrects vertical distortion only,
not correct horizontal distortion.
• The Auto keystone function can not work when
the Ceiling feature is set On in the Screen menu
(pp. 37, 45).
• Perfect correction of the image distortion can not
be ensured with the Auto setup function. If the
distortion is not corrected properly by pressing the
AUTO SET button, adjust manually by pressing
the KEYSTONE button on the remote controller or
selecting Keystone in the Setting menu (pp. 37,
45).
• Fine sync, Total dots, Horizontal position and
Vertical position of some computers cannot
be fully adjusted with the Auto PC Adjustment
function. When the image is not provided properly
with this operation, manual adjustments are
required (pp. 32-33).
Auto setup
Auto input
This function detects the input signal
automatically. When a signal is found, the search
will stop. Use the Point ▲▼ buttons to select
one of the following options.
Off ....... Auto input does not work.
On 1..... Auto input works under the following
situation.
– When pressing the AUTO SET
button on the top control or the
remote controller.
On 2......Auto input works under the following
situation.
– When turning on the projector by
pressing the POWER button on the
top control or the remote controller.
– When pressing the AUTO SET button
on the top control or the remote
controller.
– When the current input signal is cut
off.*
* If the Blank or Freeze function is active,
cancel it to activate the Auto input. It is
also unavailable when On-Screen menu is
displayed.
Auto PC
On...............Enables Auto PC Adjustment when
pressing the AUTO SET button
on the top control or the remote
controller.
Off...............Disables Auto PC Adjustment.
Auto keystone
Auto..........Always works and corrects
keystone distortion according to the
projector's tilt.
Manual......Works only when pressing the
AUTO SET button on the top
control or the remote controller.
Off.............Disables Auto Keystone.
Auto setup
 Note:
• While Auto input is set to On 1 or On 2, the
status of Input and Lamp are displayed every time
the signal is switched.
• Only the last selected input source can be
detected.
This function enables Auto input, Auto PC and
Auto Keystone adjustment by pressing the AUTO
SET button. Settings for those functions can be
altered as follows: