Audiovox ACC-52 - Manual (Page 6)

PROCEDURE FOR HORIZONTAL INSTALLATION
INSTALLATION
The unit can be installed horizontally, vertically or at a 45° angle. The position of the built-in anti-vibration springs (left and right
side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen,
the anti-vibration compensation will not be effective and vibration may cause the disc to skip.
CAUTION: After setting the built-in anti-vibration springs, place the supplied Seals (B) over the holes. These seals are used
to keep dust, which could cause a malfunction, out of the unit.
position "H"
position "V"
HORIZONTAL INSTALLATION
Set the left and right anti-vibration
springs to position "H".
VERTICAL INSTALLAITON
Set the left and right anti-vibration
springs to position "V".
45° ANGLE INSTALLATION
Set the left and right anti-vibration
springs to position "45°".
H
V
45
H
V 45
Drill holes 4mm in diameter.
1
2
3
Attach bracket (L) and bracket (R) to each side of the unit,
using the hexagonal bolts with washer base (M5 x 10)
Determine the mounting location, and drill four mount-
ing holes.
Secure the unit in place, using four self-tapping screws
(M5 x 12).
Use RTV (silicone sealer) on screw threads or around
the holes to prevent moisture intrusion.
Never mount the unit near the fuel tank.
Bracket (R)
Bracket (L)
Hexagonal bolt (4)
with washer base (M5 x 10)
A n t i - v i b r a t i o n
springs position
NOTE: Use seals (A) to cover unused
mounting holes on sides of unit.
H
V
45
V
4 5 H
position "45°"
45 °
H V
45
6
Bracket (R)
Self-tapping screw (M5 x 12)
Bracket (L)