APPLIED ENGINEERING GS-RAM III - Manual (Page 15)

5) S e t t h e S w i t c h e s .
You must have the switches in the proper position in order for the
correct amount of memory to be used. Your board may use either
Flip Switches or Rocker Switches. Refer to the drawing below for
proper settings.
M e m o r y | S w i t c h 1 | S w i t c h 2
1 Megabyte | Off | Off
2 Megabytes | On | Off
3 Megabytes | Off | On
4 Megabytes | On | On
Flip Switches
Rocker Switches
S e t t h e S w i t c h e s
6) Reinstall the card then test it using the appropriate
The memory test is included on the AW 3 Expander disk. The test
will give a graphic representation of the card and indicate which chips
are missing, bad or improperly installed.
Ch. 3 - Adding More Memory 11
+ Warning: Make sure that the end marked “FRONT” on
the card is toward the front of the computer.
1 Meg 2 Meg 3 Meg 4 Meg
1Meg 2 Meg 3 Meg 4 Meg