Alto-Shaam Halo Heat 300-HW/D6 - Manual (Page 8)

Hot Food Drop-In Well Operation & Care Manual • 7
I N S T A L L A T I O N
400-HW & 500-HW REMOTE CONTROL HOUSING MOUNTING INSTRUCTIONS
1.
Cut a 9" x 4-1/2" (228.6mm x 114.3mm) opening in the location where the control is to be positioned.
2.
Thoroughly clean and dry the mounting surface around the control cut-out opening on which the decor face will be
applied.
NOTE:
The control face will not properly adhere to an unclean surface.
3.
Remove the protective film from the mounting tape on the inside flanges of the decor face and apply the decor face
to the mounting surface.
4.
Position the remote control housing behind the decor face. Use the two (2) mounting screws through the thermostat
bezel of the decor face to fasten the decor face to the control housing.
5.
Insert the thermostat knob(s) onto the thermostat shaft(s).
PAN DIVIDER
BARS #16019
FLEXIBLE WATER-
TIGHT TETHER
MOUNTING
SCREWS
THERMOSTAT KNOB
BEZEL
DECOR FACE
Apply a food grade silicone
along the outside edge of
the hot well support flange.