Built-in microwave, Electrolux major appliances, n.a – Electrolux EI24MO45IBEI27MO45TS User Manual
Page 2
Built-In Microwave Specifications
•
Product Weight (Microwave with Trim Kit) – 51 Lbs.
•
Voltage Rating – 120V / 60 Hz / 15 or 20 Amps
•
Connected Load (kW Rating) @ 120 Volts = 1.5 kW (For use on
adequately wired 120V, dedicated circuit having 2-wire service with a
separate ground wire. Appliance must be grounded for safe operation.)
•
Amps @ 120 Volts = 13 Amps
•
Always consult local and national electric codes.
•
Allow 21" minimum clearance for 90° door swing.
•
Installation requires use of 30" or 27" Trim Kit (ordered by individual part
number and shipped separate). Includes Bottom Duct Assembly.
•
Minimum 20" deep oven cutout dimension is critical for proper installation
for oven and faceplate to fit flush against cabinet front.
•
Consult local building code, in the event that cutout opening may be
required to be enclosed with sides, ceiling and rear partition.
•
Full oven base of solid plywood or similar material required, capable
of supporting 100 Lbs.
•
Base must be level and front of cabinet square for proper operation.
•
Grounded outlet should NOT be located in shaded area, as indicated,
unless cabinet depth is greater than 21".
•
Can NOT be installed above any gas wall oven.
•
Built-In Convection Microwave can be built in alone or is approved to be
used in combination with any Electrolux Electric Single Wall Oven and / or
Warmer Drawer. (Refer to model-specific Combination Installation
Specification pages on web.)
•
When used in combination with another Electrolux built-in product, a
minimum clearance of 2-7/8" required from bottom of Built-In Microwave
cutout to top edge of companion product’s faceplate, leaving a 2" visible
gap between both product faceplates.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at electroluxappliances.com for detailed instructions.
Built-In Microwave
EI24MO45I B
High standards of quality at Electrolux Home Products, Inc. mean
we are constantly working to improve our products. We reserve the right
to change specifications or discontinue models without notice.
Electrolux Major Appliances, N.A.
USA
•
10200 David Taylor Drive
•
Charlotte, NC 28262
•
1-877-4electrolux (1-877-435-3287)
•
electroluxappliances.com
CANADA
•
5855 Terry Fox Way
•
Mississauga, ON L5V 3E4
•
1-800-265-8352
•
electroluxappliances.ca
EI24MO45I 05/13
© 2013 Electrolux Home Products, Inc.
*Note: When used in combination with
another Electrolux built-in product, a
minimum clearance of 2
7
/
8
" required from
bottom of Built-In Microwave cutout to top
edge of companion product’s faceplate,
leaving a 2" visible gap between both
product faceplates
30" min.
20"
min.
7
/
8
"
Faceplate
overlap
16
1
/
4
"
min.
16
3
/
8
"
max.
Full
plywood
base
required
to support
100 lbs.
25
1
/
4
" min.
25
3
/
8
" max.
2"
(visible
gap)*
Allow at least
21" clearance for door
depth when open
24
"
17
3
/
4
"
Power cord
location (right
top rear)
13
3
/
8
"
rear
extrusion
120V / 60Hz
grounded outlet
20" min.
4"
6"
4"
25
1
/
4
" min.
25
3
/
8
" max.
16
1
/
4
"
min.
16
3
/
8
"
max.
Bottom Duct Assembly
Outlet should NOT
be located within
shaded area UNLESS
cabinet depth is
greater than 21"
2
5
/
16
"
30" or 27"
Trim Kit Faceplate
18
1
/
16
"
(30") 30"
(27") 27"