Electrolux EIFLS55IMB - Manual (Page 20)

20 Operating Instructions
DELAY START
Use delay start with any cycle to select a wash
time convenient to your schedule or during off
peak energy hours. The start of the cycle can be
delayed for up to 14 hours. The delay time select-
ed will be displayed as 30, 60, or 90 minutes or 2
through 14 hours.
CONTROL LOCK
To lock the controls between cycles, press and
hold the control lock button for 5 seconds. Re-
peat to unlock the controls when you are ready to
operate the washer. Use this feature to reduce the
likelihood of accidental operation by children.
STATUS DISPLAY
The estimated total cycle time will be displayed
when the cycle is selected. The time may increase
if water pressure is low, oversudsing occurs or the
load becomes unbalanced. The approximate time
remaining will be displayed during the cycle.
A situation where oversudsing has been detected
by the washer will result in the washer automati-
cally adding up to 4 extra rinses to attempt to clear
the suds. Each extra rinse the washer performs
to clear the suds will add 5 minutes to the cycle
display time. If an excessive amount of detergent
has been added and additional rinsing has not cor-
rected the issue,
TOO MUCH DETERGENT will be
displayed.
DRUM LIGHT
The drum light will come on whenever the door is
opened to illuminate the drum during loading and
unloading. Closing the door turns off the light. The
drum light will automatically turn off if the door is
left open more than 3 minutes.
REVERSIBLE DOOR
Your washer is equipped with a reversible door.
The door can be hinged on the right or left side.
NOTE
For step-by-step instructions on DOOR
REVERSAL, refer to the Installation Instructions
supplied with this washer.
DOOR LOCK
PREWASHING
WASHING
ADDING STEAM RINSING
DRAINING
SPINNING
CYCLE COMPLETE
STATUS DISPLAY
The following will also be displayed at the
appropriate times during the cycle:
SYSTEM CLEAN
To clean and freshen the washer, perform the SYS-
TEM CLEAN cycle. If you wish to begin the cycle,
press select when prompted. This maintenance
cycle uses hot water and two rinses to remove
residue that may cause odor. See Inside Routine
Cleaning (Preventative) for detailed information
about the SYSTEM CLEAN cycle.
NOTE
The washer will automatically prompt you to
run the SYSTEM CLEAN cycle every 50 cycles.
You may press the cancel button to manually
perform the cycle at another time.
Washer Features