AMX Power Current Sensors PCS - Manual (Page 16)

Operation and Programming
12 PCS and PCS2 Power Current Sensors
! A one- or two-second delay.
! Verification of status changes.
During transitions between states, the PCS may take 1 to 2 seconds to stabilize and its output
indication may be incorrect. Failure to observe this delay may cause the Axcess, Axcent
2
, or
Axcent
3
system to repeatedly cycle power on the unit being sensed.
PCS2 Programming
When connecting a unit/system to the PCS2, be aware that a 1 or 2 second PCS2 circuitry
stabilization consideration must be accounted for.
During transitions between states, the PCS2 may take 1 to 2 seconds to stabilize and its initial
output indication may be incorrect. Failure to account for this possible de-lay may cause the
Axcess, Axcent
2
, or Axcent
3
system to repeatedly cycle power on the unit being sensed.