Solutions to common problems, Dishwasher won’t fill, Dishwasher has an odor – Electrolux EWDW6505GS User Manual

Page 21: Error codes, Removing spots and film

Advertising
background image

21

DISHWASHER WON’T FILL

Check to see if the water supply is turned on.

Add 1/2 cup of water to the bottom of the unit
and start again.

DISHWASHER HAS AN ODOR

Soiled dishes left in dishwasher too long can
create an odor. Use Rinse cycle.

There will be a “new” smell when first
installed. This is normal.

Check to see if unit is draining properly (See
Dishwasher Does Not Drain Properly, page
20).

NOTE

If these conditions persist, a home water
softener should be considered.

Solutions to Common Problems

ERROR CODES

In certain situations which are critical to the
machines function and safe operations.

Error 01

Leak Detector - When water is detected under
the tub.

Error 02

Thermistor - When thermistor/turbidity module
fails

Error 03

Wash Pump - Wash pump not operating

Error 04

Drying Damper - Drying damper not operating

Error 05

Upper Fan - When in the dry cycle, the control
board does not receive proper speed feedback
from the upper fan

Error 06

Lower Fan - When in the dry cycle, the control
board does not receive proper speed feedback
from the lower fan

Error 07

Drain Valve - When in the drain mode, the control
board does not receive proper position feedback
from the drain valve

Error 08

Tactile or touch switch - Control board has
verified a switch on the user interface is bad or
shorted

Error 09

Communications - Communication failure be-
tween main user board and power supply

Error 10

Mains Relay - Failure in the mains power relay

Error 11

Drain Valve - Time out before finding a state for
the drain valve

Error 12

Drain Valve - The drain valve is running when it
should be off

Error 13

System wide - Lost control of the State Machine

To remove build-up, spots and film, clean

using the following instructions:

1 Load clean dishes and glasses in normal

manner. Do not load any metal utensils or
silverware.

2 Do not add detergent.

3 Select the NORMAL WASH cycle. Press

START/CANCEL pad and close door.

4 Allow dishwasher to run until it begins the

second fill. Open door and pour 2 cups of
white vinegar into the bottom of dishwasher.

5 Close and latch door and allow cycle to

finish.

Hard water can cause lime deposit build-up on the
interior of the dishwasher. Dishes and glasses may
also get spots and film for a number of reasons
(See Glassware/Flatware Spotted or Cloudy, page
19).

REMOVING SPOTS AND

FILM

Advertising