Electrolux EPWD15IW - Manual (Page 4)

4
Washer on pedestal: Dryer on pedestal:
Attach pedestal to appliance
Installing or re-installing appliance
Turn pedestal on its side to match orientation to appliance. 1.
Slide pedestal up to appliance and line up holes in mounting 2.
brackets with holes in appliance base.
Attach rear and front brackets to appliance base with supplied 3.
screws into aligning holes - one in each front bracket and two in
each rear bracket.
Using more than one person, carefully return appliance and ped- 4.
estal to upright position.
After retuning appliance upright, loosen each mounting screw 5.
going into appliance base. Allow the appliance to settle in the
brackets and retighten each mounting screw.
Slide washer/pedestal into place. 1.
Check for levelness and rock all four (4) legs again. Repeat 2.
until level and solid.
Refer to Wa 3. sher Installation Instructions for complete details
on installing water, drain, or electrical.
Slide dryer/pedestal into place. 1.
Check for levelness and rock all four (4) legs again. Repeat 2.
until level and solid.
Refer to 3. Dryer Installation Instructions for complete details on
installing electrical, gas, or exhaust venting.
IMPORTANT
DO NOT use open dispenser drawer of washer or dispenser
cavity as hand-hold location when tipping washer upright.
Serious damage could occur to your washer.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one person move
or lift the appliance.
WASHER:
DRYER: