Appendix b connector part numbers – Ampro Corporation 420 User Manual
Page 67
CoreModule 420
Reference Manual
61
Appendix B
Connector Part Numbers
Table B-1 provides the non-standard RoHS connectors, including the manufacturers and part numbers,
used on the CoreModule 420. These part numbers can be used to determine the mating connectors,
when making your own cables.
Table B-1. Connector and Manufacture’s Part Numbers
Connector
Pin Number/Pin Spacing/
Orientation
Manufacturer
Manufacturer’s PN
J2 – Ethernet
8-pin, 0.1", right angle
AMP/Tyco
3-647079-8
J3 – Serial 1,
J5 – Utility,
J7 – Power,
J9 – Serial 2
10-pin, 0.1", right angle
TEKA
ZR205A1CC-NS-00
ZR205A1BC-NS-00
J4 – Floppy/
Parallel
26-pin, 0.1", right angle
TEKA
ZR213A1BC-NS-00
ZR213A1CC-NS-00
J6 – IDE
44-pin, 2 mm, straight
TEKA
HM222CB1N-191-00
HM222CC1N-191-00
J8 – GPIO,
10-pin, 2 mm, straight
TEKA
HM205CB1N-191-00
HM205CC1N-191-00
J10 – USB
5-pin, 0.140", right angle
Tyco
3-641216-5
J11 – Video
44-pin, 2 mm, right angle
Adam Tech or
Samtec
2PH2R44SGAHT
TMM-122-01-SM-D-RA
J13 – Serial 3,
J14 – Serial 4
10-pin, 0.1", straight
Molex
15-91-3100
Note: The following list provides the Manufacturer abbreviations used in this table and the web sites
where you can locate the required mating connector information.
• Adam Tech = Adam Technologies at
• Samtec = Samtec, Inc. at
• Molex = Molex Inc. at
• TEKA = Teka Interconnection Systems at
• Tyco = Tyco Electronics Corp at