Applications, Rear panel sra-120 – Ashly SRA SRA-120 User Manual
Page 2
Ashly Audio Inc., 847 Holt Road, Webster, NY 14580-9103, Toll Free (800) 828-6308, Telephone (585) 872-0010, FAX (585) 872-0739
Internet: http://www.ashly.com, email: [email protected]
Ashly manufactures a complete and comprehensive line of Graphic and Parametric Equalizers,
Electronic Crossovers, Power Amplifiers, Compressor-Limiters, Mixers, and
Amplifier Input Options. Please call, write or visit our web site for information on any of these Ashly Products.
Applications:
Churches, Studios, Concerts, Dance Clubs, PA Systems, Auditoriums, Lecture Halls, Sports Stadiums, Outdoor Festivals
General Specifications SRA-120
EIA SPECIFICATION (± 1dB, <1% THD, 20Hz-20kHz)
Stereo (Rated Per Channel)
4 ohm:
60W
8 ohm:
45W
Mono Bridged
8 ohm:
120W
FTC SPECIFICATION
(< 0.1% SMPTE IM)
Stereo (Rated Per Channel)
4 ohm:
55W
8 ohm:
40W
Mono Bridged
8 ohm:
110W
Total Harmonic Distortion:
Stereo @ 35W per channel into 8 ohm)
< .01% 1kHz, < .05% 20Hz-20kHz
IM Distortion:
(stereo @ 35W per channel into 8 ohm)
< .01%
Damping Factor:
>200, 8 ohm, <1kHz
Slew Rate:
(Stereo Operation)
>10V/µS
(Mono Bridged Operation)
>20V/µS
Frequency Response:
±0.2dB (35W/ch, 20Hz-20kHz)
Output Noise & Hum:
(20Hz-20kHz unweighted) 100 dB
below full output
Input Impedance:
20K ohm balanced
Input Sensitivity:
(switchable) .775Vrms or .245Vrms
Voltage Gain:
(switchable) 26.0dB or 36.0dB
Output Protection:
Instantaneous protection from shorted output
and voltage-current overload limiting.
Load Protection:
2 second output turn-on delay and instanta
neous turn-off to protect load from transients.
Subsonic and ultrasonic filtering.
Thermal Protection:
Thermal sensing on each channel will turn off
outputs independently under overheat condi
tions
Power Requirements:
350W max, 30W idle @ 120VAC, 50Hz-60Hz.
(240VAC available)
Cooling: Convection
cooled
Connectors:
Input:
1/4 phone jacks and barrier strip.
Output:
5-way speaker binding posts, 1/4 headphone
jack
Controls:
Rear panel: stereo/mono switch, bridge/normal
switch, sensitivity switch and ground lift
jumper. Front panel: two attenuator controls
and front panel power switch.
Indicators:
Front panel signal present, clip and protect
LEDs for each channel
Dimensions:
19L x 10D x 1.75H
Shipping Weight:
20lbs
Rear Panel SRA-120