Aiwa CA-DW539 - Manual (Page 9)

ENGLISH
9
PROGRAMMED PLAY
Up to 30 tracks can be programmed from the disc.
1
In stop mode, keep * s MEMORY pressed
until “M” flashes in the display.
* or s STOP on the remote control
2
Press r or t to select a track, then
press s MEMORY to store it.
To select a track with the remote control
Press the numbered buttons 0-9 and +10.
3
Repeat step 2 to program other tracks.
4
Keep s MEMORY pressed until “M” stops
flashing to finish the program.
“M” remains displayed and indicates the unit stores
the programmed tracks.
5
Press e to start play.
To check the program, press r or t in stop
mode.
To clear the program, press s once in stop mode so
that “M” disappears in the display.
To change the programmed tracks, clear the
program and repeat all the steps again.
Track number
Programmed number
SETTING THE SLEEP TIMER
The unit can be turned off automatically at a
specified time.
1
Keep REPEAT/SLEEP/FM MODE/OSC
pressed until “30” flashes in the
display.
2
Within 4 seconds, press r or t to
specify the time until the power is
turned off.
Each time it is pressed, the time changes
between 10 and 90 minutes in 10-minute steps.
To check the time remaining until the power
is turned off
Repeat step 1 shown above. The remaining time is
displayed for 4 seconds.
To cancel the sleep timer
Display the remaining time and press r or t
repeatedly until OFF is displayed.
NOTE
If the unit is turned off during tape playback, c on
the deck will not be released. Press Z to
release c .
Specified time
While the sleep
timer works, the
dot keeps flashing.
En