Electrolux ENF4451AOX - Manual (Page 32)

Problem Possible cause Solution
The mains plug is not con-
nected to the mains socket
correctly. Connect the mains plug to
the mains socket correctly.
The appliance has no pow-
er. There is no voltage in
the mains socket. Connect a different electrical
appliance to the mains sock-
et.
Contact a qualified electri-
cian.
The lamp does not
work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the
lamp".
The compressor op-
erates continually. The temperature is not set
correctly. Set a higher temperature.
The door is not closed cor-
rectly. Refer to "Closing the door".
The door has been opened
too frequently. Do not keep the door open
longer than necessary.
The product temperature is
too high. Let the product temperature
decrease to room tempera-
ture before storage.
The room temperature is
too high. Decrease the room temper-
ature.
Water flows on the
rear plate of the re-
frigerator. During the automatic de-
frosting process, frost de-
frosts on the rear plate. This is correct.
Water flows into the
refrigerator. The water outlet is clogged. Clean the water outlet.
Products prevent that wa-
ter flows into the water col-
lector. Make sure that products do
not touch the rear plate.
Water flows on the
ground. The melting water outlet
does not flow in the evapo-
rative tray above the com-
pressor. Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low/too high. The temperature regulator
is not set correctly. Set a higher/lower tempera-
ture.
The temperature in
the refrigerator is too
high. There is no cold air circula-
tion in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
The temperature in
the freezer is too
high. Products are too near to
each other. Store products so that there
is cold air circulation.
32 www.electrolux.com