American Audio Q-2221/X - Manual (Page 5)

1. FEATHER FADER PLUS™ CROSSFADER - Mixes the signals of channel 1 and channel 2. When the
crossfader is set in the center position, both channels can be heard at once.
2. HAMSTER SWITCH - Changes the polarity of the Crossfader (for crabbing). Channel 1 will be activated
by the right side of the crossfader (mixing from right to left), and Channel 2 will be activated by the left
side of the crossfader (mixing from left to right).
3. CHANNEL FADER - These faders control the output level of each channel.
4a. CHANNEL 1 TRANSFORMER SWITCH (CHANGEABLE) - Used to select the input to be sent to channel
1. TRANSFORMER SWITCH may be used up/down or left/right. To change the switch, see diagram on
page 9.
4b. CHANNEL 2 TRANSFORMER SWITCH (CHANGEABLE) - Used to select the input to be sent to
channel 2. TRANSFORMER SWITCH may be used up/down or left/right. To change the switch, see
diagram on page 9.
5. PFL BUTTONS - Depressing these button sends the PFL (Pre-Fader Level) input signal to the cue level
controls (14, 15, and 16). This allows you to monitor an input signal in a pair of headphones.
12 10 8
3
4a
11
4b
18
17
1
2
19
9
6
14
15
13
16
7
5
Front Panel - Functions and Controls
©
American DJ Supply
®
- www.americandj.com - Q-2221/X User Instructions page 5