Bosch B36BT830NS - Manual (Page 10)

10
Required accessories and tools
Supplied accessories
 Installation instructions
 Operating instructions
 Installation kit
Optional accessories
Heater Kit for Side-by-Side installation BOHEATKIT10
If the gap between the appliances is less than 6" (160 mm).
Other required accessories
Ice maker installation kit 1 /
4
" OD copper line
For connecting appliances which require water,
e.g. for an ice maker.
Maximum outer diameter of the water pipe
(without fittings):
3
/
8
" (9.5 mm).
Other
 Stepladder
 Dolly, hand truck
 Hammer drill for drilling holes in wall or floor
 Bits according suitable for material and in different
sizes
 Wooden beam (cross section min. 3" x 4") as an
alternative tilt protection, length according to the
width of the installation cavity
 Wooden screws in different sizes
 Thin (max. 1 /
16
" (1.5 mm)), suitable material to
protect the floor from damage (e.g. lino)
 Suitable material for covering and protecting
furniture (e.g. protective sheets)
 Adhesive tape
Note:
Before using, check whether the removed adhesive
tape leaves adhesive residue on the work surfaces!
Otherwise do not use on high-quality work surfaces.
Tools
Cordless screwdriver
Torx bit T20 and T30 +
magnetic holder
Torx screwdriver T20
5 /
16
" (8 mm) hex nut driver
Wood drills in different sizes
Open end wrench 1 /
2
"
(Width across flats 13 mm)
Multigrip pliers
Adjustable wrench
Cutter with adjustable blade
Metal tape measure,
folding rule
Square
Level, length 2' (60 cm) and
4' (1,2 m)