Bosch HBL8651UC - Manual (Page 2)

English 1
IMPORTANT UPDATES
BUILT-IN OVEN INSTALLATION INSTRUCTIONS
AND USE AND CARE MANUAL
The following content updates the built-in oven Installation Instructions and the Use & Care Manual. Please note
the referenced sections and refer to the content below for updated information.
Removing Packaging
• Cut straps on the outside of the box.
• Remove the cardboard box by lifting it up and off the
unit.
• Remove all top and side cardboard and Styrofoam
braces.
• Place the oven (leaving it on the shipping base) in front
of the cabinet where it is to be installed.
• Remove all accessories, racks, packing materials and
literature from the oven cavity (for double ovens,
remove such items, if present, from both cavities).
• Unscrew unit from packaging brackets as shown below
in “Packaging Bracket Removal.”
Note: The screws near the base mounting bracket are
all torx head (T-20 size). Only the one screw that goes
through the slotted hole in the mounting bracket on the
left and right sides of the unit needs to be removed in
order to lift the unit from the mounting base (the screw
circled and shown as “A” in the illustration below.)
Packaging Bracket Removal (left and right sides)
Note:
Different models use different packaging materials. Actual
brackets may look differently. The bracket remains in the
packaging base. The unit should stay on the packaging
base until ready to be lifted into cabinet cutout.
Installation
Parts Provided
Omit Step 5 in the “Placing the Oven Into the Cabinet
Opening” section referencing installation of the oven
bottom trim. The bottom trim is already installed.
NOTICE
Remove one screw only from each bracket. This
will release your oven from the shipping base. Do
not remove any additional screws from the oven.
Oven Mounting Screws
8 screws are included to
secure the oven trim to the
cabinet. The screws are
located in a small plastic
bag affixed to the literature
pack bag.
The bottom trim pictured below is pre-installed at the
factory. The part is not included as a separate piece as
noted in the installation manual.
Oven Bottom trim (installed at factory)