Bosch B26FT70SNS - Manual (Page 8)

8
Aligning the appliance
NOTICE
To ensure that the appliance
operates correctly, use a level to align
the appliance.
If the appliance is not level, water
may flow out of the ice maker, ice
cubes may be irregular, or the doors
may not close properly.
1. Place the appliance in the
designated location.
2. Remove the three screws from the
base panel.
3. Remove the base panel.
4. Use a hexagonal wrench to loosen
the two front feet until they are
firmly planted on the floor and then
align the front of the appliance.
5. Use a hexagonal wrench to turn the
screws and then align the rear of
the appliance.
To raise the rear of the appliance:
Turn the screw clockwise.
To lower the rear of the appliance:
Turn the screw counterclockwise.
6. Use the level to check if the
appliance is level.
NOTICE
To ensure that the appliance does
not move, the front feet must be
firmly planted on the floor.
7. If the height of the refrigerator
compartment doors are uneven or if
the freezer compartment drawer is
slanted after adjusting the level of
the appliance, use the following
method to adjust them.
en