Bosch WTB86201UC - Manual (Page 30)

30
Troubleshooting
Introduction
NOTICE: Before doing maintenance work or trying to
rectify a problem by yourself, rotate the program selector
to Off.
The program will not continue running when the power
supply has been restored. Desired program must be
selected again and start button pressed.
9 WARNING
RISK OF INJURY TO SKIN
The door, the drum and the laundry may be hot.
9 WARNING
RISK OF ELECTRIC SHOCK! EXPLOSION HAZARD
Repairs or replacement of parts should be carried
out by authorized technicians only.
Before calling the customer service, check whether you
can rectify the fault yourself by means of the following
table.
If a fault cannot be rectified or a repair is required:
1. Set program selector to the Off.
2. Pull the mains plug out of the socket.
3. Call customer service.
~ Customer service; Page 4
Troubleshooting
If you encounter a problem, it often will merely be
something minor. Before you call customer service,
consider the suggestions and instructions below:
NOTICE: The troubleshooting items listed below can
help you resolve minor issues with your dryer quickly and
without the necessity of waiting for a service call.
Service calls for issues that could have been solved by
using this table may not be covered under the
warranty. Please rule out any of these issues before
calling customer service.
Determing the Problem
Problem Possible cause(s) Solution(s)
Dryer does not start.
Start/Pause indicator
light does not illumi-
nate.
Main plug not inserted at all or not
inserted correctly.
Insert main plug correctly.
A fuse of power supply is tripped. Replace/switch on fuse.
Start/Pause button not pressed. Press Start/Pause button.
Door not closed properly. Check if laundry is caught in the door, address the
issue. Close the door until a click is heard.
Ambient temperature below 41 ° F/
5 ° C.
Increase room temperature.
~ Your dryer is intended for; Page 5
Program not selected. Rotate the program selector to desired program.
~ Program selection table; Page 20
The display panel light-
ing and indicator lights
go out, Start/Pause
indicator light flashes.
Energy-saving mode is activated. Press any button to activate the lighting.
~ Environmentally friendly use of your dryer; Page 7
The display panel
switches off.
Sleep mode after setting the Fin-
ished in option is activated.
Press any button to activate the lighting.
The Cleaning req. indi-
cator light up.
Lint filter dirty. Clean lint filter.
~ Cleaning the lint filter; Page 27
Press the Start/Pause button to reset the displayed
indication and then press Start/Pause button again to
reset the appliance if necessary.
Heat exchanger dirty. Clean heat exchanger.
~ Cleaning the heat exchanger; Page 28
Press the Start/Pause button to reset the displayed
indication and then press Start/Pause button again to
reset the appliance if necessary.