Bosch B22CS30SNS - Manual (Page 8)

8
Water connection
Have a technician install the
appliance and connect it to the
water supply according to the
enclosed installation instructions.
A cold water connection is required
for operation of the automatic ice
maker.
The water pressure must be
between 29 and 116 psi
(2.0–8.0 bar).
The installation must comply with
local plumbing regulations and local
and state laws.
A separate shut-off valve must be
installed for the appliance water
connection.
The shut-off valve for the water
connection must not be behind the
appliance. It is recommended to
place the shut-off valve directly next
to the appliance (base unit) or in
another easily accessible location.
Installing and
connecting the
appliance
̨ Have a technician install and
connect the appliance
according to the enclosed
installation instructions.
̨ After installing the appliance,
wait at least 1 hour until the
appliance starts up.
During transportation the oil in
the compressor may have
flowed into the refrigeration
system.
̨ Before switching on the
appliance for the first time, clean
the interior of the appliance
(see “Cleaning”).
̨ Always connect the water
before the power.
̨ Apart from statutory national
regulations, you should stick to
the connection terms relating to
the local electricity and water
companies.
̨ Do not remove the transpor-
tation protection devices from
the shelves and storage
compartments until the
appliance has been installed.
Aligning the appliance
To ensure that the appliance
functions correctly, it must be set
level with a spirit level.
If the appliance is not level, water
may flow out of the ice maker, ice
cubes may be irregular or the doors
may not close properly.
̨ Place the appliance in the
designated location.
̨ Align front feet with a hexagon
wrench.
̨ Align rear feet with an Allen key.
NOTICE
The maximum external diameter of
the water line (without connecting
pieces) is
13
/
32
" (10 mm).