Electrolux EWC1350 - Manual (Page 20)

Important! Do not use the hose from
your previous machine to connect to the
water supply.
2. The machine end of the inlet hose can be
turned in any direction. Set the hose cor-
rectly by loosening the ring nut. After po-
sitioning the inlet hose, be sure to tighten
the ring nut again to prevent leaks.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
Important! Before connecting up the
machine to new pipework or to pipework that
has not been used for some time, run off a
reasonable amount of water to flush out any
debris that may have collected in the pipes.
Water drainage
The end of the drain hose can be positioned
in three ways:
Hooked over the edge of a sink using
the plastic hose guide supplied with
the machine.
In this case, make sure the end cannot come
unhooked when the machine is emptying.
This could be done by tying it to the tap with
a piece of string or attaching it to the wall.
In a sink drain pipe with a trap.
650-800 mm
The drain hose can be connected directly in-
to the pipe (e.g. beneath a washtub or sink),
above the water trap. The drain hose must
be arranged so that some part of it’s length
is routed up to a level corresponding to the
top edge of the tub and fixed in place there.
Directly into a drain pipe at a height of not
less than 65 cm and not more than 80 cm.
Their must be an air gap around and below
the end of drain hose. This means that the
internal diameter of the standpipe must be
larger than the outer diameter of the hose.
20 electrolux