Alliance Laundry Systems 25 - Manual (Page 14)

Operating Instructions
70400201 12 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Control Instructions
Figure 3
Electromechanical Coin Control
CD and CX Control Suffixes
1. Set the TEMPERATURE selector at HIGH or
LOW, or anywhere between these settings.
2. Coin Drop Models: Insert the coin(s) in the coin
slot, turn the knob to the right and release it.
3. Press the PUSH TO START button and hold it for
approximately three (3) seconds.
NOTE: Additional drying time may be purchased
at cycle start, or while tumbler is running, by
adding additional coin(s).
IMPORTANT: If the loading door or lint panel
door is opened during the cycle, the heating system
will shut off and the motor will stop. However, the
timer will continue to run. To restart the cycle, both
doors must be closed and the PUSH TO START
button must be pressed in.
4. When the cycle is complete, open door and
remove the laundry.
TMB807N
PUSH
TO
START
HIGH
TEMPERATURE
LOW
INSERT QUARTER
TURN KNOB
QU
ARTERMASTE R
25
1 2 3
SELECT
TEMP INSERT
COIN PUSH
START