Avaya 16-300043 - Manual (Page 17)

Registering the Phone
Issue 3 April 2006 17
Registering the Phone
If this is the first time you are using your 4601 IP Telephone, you may be required to register the
phone with the call server. Alternately, in the rare instance that your phone has been logged off,
the phone is no longer connected to the call server. A logoff state is indicated by both Message
LEDs flashing and by having no dial tone. Use this procedure to register or re-register your
telephone with the call server.
1. Using the dial pad, enter your Extension number, then press # (the pound
button). If you do not know your Extension, see Determining Your Telephone’s Extension
Number .
2. Using the dial pad, enter your Password, then press #.
The 4601 is now ready for use.
Determining Your Telephone’s Extension Number
Your phone must be logged off to determine the Extension number. Because the 4601 IP
Telephone has no display area, it uses its LEDs to provide feedback.
1. To determine your Extension, press the * (asterisk) button.
The two Call Appearance Line indicators alternate flashing out the Extension number, with a
slight pause between flashes.
For example, if the Extension is 2430, the following flash sequence occurs:
● Call Appearance Line a’s indicator winks twice to indicate the first digit of the extension
is 2,
● Call Appearance Line b’s indicator then winks four times to indicate the second digit of
the extension is 4,
● Call Appearance Line a’s indicator winks three times to indicate the third digit of the
extension is 3, and finally,
● Call Appearance Line b’s indicator flutters five times (rather than winks) to indicate the
last digit is zero.
Note:
Note:
For help with interpreting LED flashes, winks and flutters, see Interpreting LED
Prompts in Chapter 3: Telephone Management and Troubleshooting .
2. Due to the flash rate timing, you may need to re-check the Extension number. If so,
repeat Step 1.