Installation, Positioning, Levelling – Electrolux ERT1606AOW User Manual

Page 32: Location

Advertising
background image

INSTALLATION

WARNING!
Read the "Safety Information" care-
fully for your safety and correct op-
eration of the appliance before in-
stalling the appliance.

POSITIONING

This appliance can be installed in a dry,
well ventilated indoor (garage or cellar) also,
but for optimum performance install this
appliance at a location where the ambient
temperature corresponds to the climate

class indicated on the rating plate of the
appliance:

Cli-
mate
class

Ambient temperature

SN

+10°C to + 32°C

N

+16°C to + 32°C

ST

+16°C to + 38°C

T

+16°C to + 43°C

LEVELLING

When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front.

LOCATION

100 mm

15 mm

15 mm

The appliance should be installed well away
from sources of heat such as radiators, boil-
ers, direct sunlight etc. Ensure that air can
circulate freely around the back of the cabi-
net.To ensure best performance, if the appli-
ance is positioned below an overhanging wall
unit, the minimum distance between the top
of the cabinet and the wall unit must be at
least 100 mm . Ideally, however, the appli-
ance should not be positioned below over-
hanging wall units. Accurate levelling is en-
sured by one or more adjustable feet at the
base of the cabinet. If the cabinet is placed in
a corner and the side with the hinges facing
the wall, the distance between the wall and
the cabinet must be at least 10 mm to allow
the door to open enough so that the shelves
can be removed.

WARNING!
It must be possible to disconnect the
appliance from the mains power sup-
ply; the plug must therefore be easily
accessible after installation.

32 www.electrolux.com

Advertising