Electrolux EXD25DN3W - Manual (Page 5)

3. After a few days when the Relative Hu-
midity has declined, press the HUMIDI-
TY
or buttons to choose a value
between 35% to 85%, so the room is
kept at a comfortable humidity. Press-
ing the
or buttons will change
the humidity selection in 5% incre-
ments. After you have set the desired
humidity, the readout will display the
actual room humidity. If at any time you
want to return to the CONTINUOUS
Mode, pressing the HUMIDITY
but-
ton will lower the Relative Humidity
through the 5% increments until the
display reads CO.
4. You can also use the FAN SPEED but-
ton to change the fan speed to
HIGH or LOW. The indicator light will
show the setting you have selected. A
higher fan speed will result in quicker
moisture removal.
5. The CLEAN FILTER light will illuminate
after 250 hours of operation. At this
time refer to the care and cleaning sec-
tion to remove and clean the filter.
Once the filter has been cleaned and
replaced, simply press the FILTER but-
ton
to extinguish the light.
6. The TIMER function enables you to ei-
ther Delay Start or Delay Stop the unit
in the choice from 0.5 hour to 24
hours. If the unit is running, then select-
ing Timer will turn the unit off in the
hours that will be set (Delay Stop). If the
unit is off, then selecting Timer will turn
the unit on in the hours that will be set
(Delay Start).
TIMER setting:
First press TIMER button
, then ad-
just timer setting, by tapping or holding
the
or button to change the de-
lay timer at 0.5 hour increments, up to
10 hours, then by 1 hour increments up
to 24 hours. The control will count
down the time remaining (8, 7.5, 7,
etc.) until the unit either starts or stops.
For the Delay Start, the fan speed and
humidity maintained will be the same as
previous setting. After TIMER setting
finishes, pressing TIMER button
again at any time will stop the TIMER
function. The Delay Start/Stop Feature
will work until the unit either starts or
stops. Once that happens the above
steps have to be repeated.
– Before entering TIMER setting, make
sure power is being supplied to the
unit.
– Before entering TIMER setting, make
sure pressing HUMIDITY or
button sets one desired room humid-
ity first.
7. To shut the unit down, press the ON/
OFF button .
electrolux 5