Water Inc HOUSEPURE HP01 - Manual (Page 8)

21 22
23 24
Installation Manual Page 6
a. Open the Inlet Valve on the Bypass.
b. Press and hold the Cycle button to put the
valve into Backwash.
a. Allow the system to backwash until the
drain runs clear or until the end of the
backwash cycle, whichever comes first.
b. Press the Cycle button to advance the valve
to the Rapid Rinse position. (The valve will
advance automatically after 9 minutes of
Backwash.)
a. Monitor the water flowing to drain dur-
ing Rapid Rinse. You want to be sure that
the water is clear. Capture some water in a
glass and inspect it to ensure that there are
no black particles.
b. Once the water is clear, you can advance
the valve to the service position.
a. If the water is not clear at the end of the
Rapid Rinse cycle, put the system in Back-
wash again by pressing and holding the
cycle button. Repeat steps 21 and 22 until
the water runs clear during Rapid Rinse.
Filter Start-Up - Tank Fill and Initial BackWash
Inlet Valve
Open
a
b
a
b
a
Note Air-Gap