Myron&Davis NV7SFT1 - Manual (Page 5)

Step 1. Remove the six mounting
screws on side both sides of the radio
Step 2. Pull the radio straight out.
Step 1a. Remove factory radio
and disconnect .
Step 1b. Remove the factory
radio.
Remove the OEM Radio and prepare the Myron and Davis Unit for installation by
following the steps below.
Note : Inspect all fasteners and brackets for damage. Replace as necessary before the
installation process is started
5 – Remove Factory Radio
Step 3. Relocate this box inside the
dash behind the radio.
Step 4. Remove the vents from the
factory trim bezel
Step 5. Re-install the vents in the
M&D radio bezel.