Myron&Davis NV7NAT1 - Manual (Page 5)

Step 1. Remove the mounting screws
at the top of the radio
Step 2. Remove the mounting screws at the
bottom of the radio
Step 1a. Remove factory radio
and disconnect .
Step 3. Pull the radio straight out of the
dash.
Step 1b. Remove the factory
radio.
Remove the OEM Radio and prepare the Myron and Davis Unit for installation by
following the steps below.
Note : Inspect all fasteners and brackets for damage. Replace as necessary before the
installation process is started
5 – Remove Factory Radio
Step 4. Carefully unplug the connectors. Step 4a. Unplug the A/C connector. Step 5. Unscrew the brakets from the
side of the radio and A/C controls.
Step 6. Remove the A/C controls from the
factory radio trim.
Step 6 Cont. Step 7. Determine which trim to use on the
factory A/C Controls