Instructions / warranty, Follow instructions carefully, Wiring – LUMATEQ LC52 User Manual

Page 2: Cleaning & maintenance, Troubleshooting, Specifications, Mounting, Warranty

Advertising
background image

LUMATEQ is a division of TACO Metals, Inc.

Visit us at LUMATEQ.com • 305.770.2392 • Fax: 305.653.8569 ©2014 All Rights Reserved

INSTRUCTIONS / WARRANTY

Wiring

Universal voltage driver permits operation at 110V-277V, 50 or 60 Hz.
• Connect the black fixture lead to the (+) LINE supply lead.

• Connect the white fixture lead to the (-) COMMON supply lead.

• Connect the GROUND wire from fixture to supply ground.

Cleaning & Maintenance

CAUTION: Be sure fixture temperature is cool enough to touch. Do not clean or

maintain while fixture has power applied.

• Clean lens and fixture with non-abrasive glass cleaning solution.

• Do not open fixture to clean the LED. Do not touch the LED.

Troubleshooting

• Check that the line voltage at fixture is correct. Refer to wiring directions.

• Is the fixture grounded properly?

• Check power supply fuse. If blown, replace with one of same size and rating.

Specifications

W

A

RN

ING!

Electrical

D

ev

ic

e

Mounting

To ensure weatherproof seal, apply weatherproof silicone sealant around

the edge of the Housing and/or Junction Box. This is especially important

with an uneven wall surface. Silicone all plugs and unused conduit entries.

1)

Loosen Door Screws with the Allen wrench provided (3/16”) and

swing open the door. Screws will remain in place with silicone washers.

2)

Un-screw the appropriate plug when mounting to junction box

(not supplied). If lag bolt mounting to surface, drill through holes

using a 9/32” Drill bit at the locations on the rear housing.

Use Leveling Bubble to level fixture.

3)

Feed supply wires through Junction Box. Check that the

Gasket is fully sealed.

4)

Make sure Housing Gasket is properly seated. Close and tighten

the Door Screws. Silicone all Plugs and unused conduit entries.

5)

If outdoor surface is irregular, use caulk to seal any gaps around the Housing.

INSTRUCT

-W

ALLP

ACK CUT OFF_40_52

Warranty

LUMATEQ products are all carefully

tested and inspected to ensure

optimal levels of performance.

LUMATEQ warrants to the original

purchaser of LUMATEQ products

to be free from factory defects in

materials and workmanship for a

period of five years from the date of

purchase. Should they be proven

defective in material or workmanship

within three years of original

purchase, they will be repaired or

replaced without charge, subject to

the performance guarantees stated

in this warranty. This warranty is

void if product has been damaged

by neglect, unreasonable use,

improper service and failure to

follow maintenance guidelines.

LUMATEQ’s liability and purchaser’s

exclusive remedy for damages shall

not be greater than the purchase

price of the actual product claimed

to be defective and LUMATEQ

shall not be liable for any indirect,

incidental or consequential damages

including, but not limited to, present

or prospective profits, reliance

expenditures or commitments,

reputation, goodwill or claims of

third parties. During this warranty

period, your LUMATEQ product

will either be repaired or replaced

without charges to the original

purchaser, when returned prepaid

and insured with proof of purchase

date. This warranty covers repair or

replacement costs and freight back

to the original purchaser-consumer.

For prompt warranty service,

contact the LUMATEQ Warranty

Department to receive your Warranty

Tracking/Authorization Number.

E-mail: [email protected]

• Phone: 800-653-8562. Please

note, dated proof of purchase must

accompany all LUMATEQ products

returned to the LUMATEQ Warranty

Department. LUMATEQ, A Division

of TACO Metals, Inc.Attention:

Warranty Dept.,1922 Smithville

Highway, Sparta, TN 38583

3 38 "

10"

6 12 "

1

1 4

"

2"

8

3 8

"

11 18 "

6

1 8

"

6 12 "

Drill 9/32"

for Lags

Follow instructions

carefully!

Junction Box

(not supplied)

Gasket

Housing

Plug

Leveling Bubble

Door

Model Number:

LC40-BRZ-110-00

LC52-BRZ-110-00

Total Lumens:

2818

3416

Input Voltage (VAC/60Hz):

110-277

110-277

Input Current (Amp): @110VAC

0.32

0.43

Input Power (W):

37

51

Color Rendering Index (CRI):

87

85

Correlated Color Temperature (K):

5700

5700

Fixture

Line

Common

Ground

Black

White

Ground

Advertising
This manual is related to the following products: