LG MV12AH - Manual (Page 21)

Owner's Manual 21
Maintenance and Service
Before performing any maintenance, turn off the main power to the system.
Grille, Case, and Remote Control
o Turn the system off before cleaning.
To clean, wipe with a soft, dry cloth. Do not use bleach or abrasives.
: Supply power must be disconnected before cleaning the indoor unit.
NOTICE
AIR FILTERS
The air filters behind the front grille should be
checked and cleaned once in every 2 weeks or
more often if neccessary.
1. Lift the front access panel and pull the filter tab
slightly forward to remove the filter.
2. Clean the filter with a vacuum cleaner or warm,
soapy water.
• If dirt is conspicuous, wash with a solu-
tion of detergent in lukewarm water.
• If hot water (40°C or more) is used, it
may be deformed.
3. After washing with water, dry well in the shade.
4. Re-install the air filter.
o Never use any of the followings:
• Water hotter than 40°C. Could cause deformation and/or discoloration.
• Volatile substances
Could damage the surfaces of the air conditioner.
Air filters
(behind front panel)
Air outlet vent
Vertical louver Horizontal louver
Air inlet vent
Vertical louver Horizontal louver
Air filters Air outlet
vent
Air inlet vent
(9k/12k) (18k/24k)
Gasoline
Powder
Maintenance and Service
Indoor Unit
NANO PLASMA FILTER(OPTIONAL)
The NANO PLASMA filter behind the air filters should be checked and cleaned once in every 3 months or more
often if necessary.
1. After opening the front grille, pull slightly
forward to remove the NANO PLASMA
filter.
2. Remove dust with vacuum cleaner or
air.
(You should not try to wash with water).
3. Note the cuts of electric discharge lines.
4. Re-install the NANO PLASMA filter to
the original position.
: Don't touch this PLASMA Filter within 10 seconds after opening the inlet grille, it may cause an electric
shock.
WARNING
NANO PLASMA
Filter
(9k/12k) (18k/24k)
1
2
ENGLISH